American Ametec AC rack mounted power supply

Low total harmonic distortion and AC noise

• Good measurement function

• Wide range power factor correction input

• Can be configured in parallel on-site

• Multiple devices can be configured for multi-phase operation

Elgarcontinuous wave(CW)Series AC power supply provides pure

Net single-phase output with excellent cost-effectiveness,

And it can provide pure single output. This type of compact

There are two series of switch mode power supplies: manual(CW-M)

Or programmable(CW-P)Having standardIEEE-488.2

andRS-232Control. Both series have three power outputs

Level:800VAThe1250VAand2500VA.800VAand

1250VAThe heights of the models are all2U(3.5inch), and

And the tested component can be connected to its front panel or back

Board.2500VAThe height of the model is3U(5.25inch)，

It has a rear panel output connection point. All models are available

Run in desktop or rack mounted configuration.

manualCWThe functions and advantages of

Through the manual series front panel knob(10Gear electric

Position meter)A device that can quickly adjust voltage, current, and frequency

Set. Can be achieved through one0to5VAnalog signal versus frequency

Remote programming and setting of voltage. Light emitting diode refers to

Display: Output enabled, voltage or current operation mode, therefore

Obstacle and slave modes. You can also use the electricity provided by the factory

Connect these models in parallel on site or configure them into three

Phase power supply. It can be selected through a switch on the rear panel

Current off mode or turn back mode.

programmableCWThe functions and advantages of

There are two bright ones on the front panel4Position7Segment display screen.

power factor correction(PFC)The universal input voltage enables

AC socket delivers the highest power without the need for user selection

Surrounding. at45Hzto500HzWithin the standard frequency range,

whether it is135 VACor270 VACThe output voltage range

Both sides can output full rated current. Both series are available

Connected together to provide more power.

Voltage, current, and other parameters can be adjusted through the encoder knob on the front panel

Program the frequency setting. You can select between two options through the button

Viewing programming settings on a LED display screen or

Measurement value. The system configuration can be set through the menu button,

Including parallel operation or three-phase operation. You can also access it through the menu

Set whether to use current off mode or turn back mode. tool

There is a standard remoteIEEE-488.2andRS-232Control connection

Mouth. LED indicator: high range output voltage or

Low range output voltage, measurement mode or programming mode

Voltage mode operation or current mode operation and output start

Use it. LED indicator menu/Status, remote control

Control, locking, and fault status. Based on digital signal processing

(DSP)The measurement includes voltage and current(Current, peak value

Current, peak factor)Power consumption(WTheVAAnd power factor

number)And frequency.

A separate output enable switch controls the delivery to the load

The power. Remote voltage sensing is a standard configuration. change

The coupling output of the voltage regulator prevents overvoltage and overcurrent. The device also

Can prevent overheating situations from occurring. Dual speed fan for low power

The noise during rate level operation is lower. All models are available

CELogo.

CWThe series has the following applications:

• Testing of sinusoidal waveforms simulated in actual power grids

•400HzTesting of aviation electronic equipment

•50/60Hzextreme testing

• Ballast testing

• Component testing

• AC/DC converter power test